Columbia-Spas Aeware Manual de usuario descargar pdf (Pagina 40)

in.xm

Warning!

There are different GFCI models used on the market.

See manufacture's instructions that come with the GFCI for

speciﬁc information. Note that all illustrations are examples only.

From

electrical box

To spa

Ground

wire

Main electrical box GFCI panel

Verify if GFCI is properly connected.

If it's not, verify GFCI diagram and reconnect it.

Verify in.xm pack wiring (make sure that the neutral and the ground

have not been inverted).

From

electrical box

To spa

Important

connections:

Neutral of

GFCI must be

connected to

neutral bus.

Neutral from

spa must be

connected to

breaker.

If the GFCI is properly connected but still tripping, unplug all

outputs from the spa pack (pumps, heater, ozonator etc).

Reconnect one output at the time until the GFCI trips again.

Replace defective component.

Note: If the neutral of the GFCI is hooked up to the neutral bar,

the in.xm spa control will only trip when the 120v outputs are ﬁred

( e.g.: the ozonator)

gfci trips

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

Sin comentarios

Columbia-Spas Aeware Manual de usuario Pagina 40